-
ON/OFF-Switches
Changeover switches
Step switches
General application switches
Series general application switches
Series-parallel general application switches
Coding switches (Exception: CHR16)
Voltmeter changeover switches
Ammeter changeover switches
Volt-Ammeter changeover switches
Control and Load switches
Control discrepancy switches
Motor switches
|
Basically the CH-series are designed for horizontal wiring. Vertical wiring is available for Panel Mounting and Base Mounting.
Panel Mounting
The Panel Mountings are well used mountings which cover wide application ranges.
They consist of two main groups.
The two/four hole mountings, which are fixed by (2/4) screws around the center shaft hole.
While with the single-hole mountings the shaft hole is used for fixation.
The two/four hole mountings provide several variations which make them fit for all tasks.
Base Mounting
Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distribution cabinets.
The switch can be mounted at the base panel by two or four screws and also by 'Snap-On for DIN rail mounting. For this mounting, several door clutches with or without padlock are available.
|
